Hardware Longevity Report
Extended bench testing of a specific miner and PSU combination over 14 days, measuring degradation, fan wear, and efficiency drift.
Learn MoreBusan · Since 2019
Match Your Miner to the Right Power Supply
We test and document ASIC hardware at 0.05 TH/s and above, then pair each unit with a PSU architecture that survives Korean voltage swings and sustained summer loads.
What We Measure Before You Buy
Every review starts at the breaker panel, not the spec sheet.
Hash Rate Verification
We run each miner at factory-rated wattage for 72 hours and record actual TH/s against the 0.05 minimum threshold, noting thermal drift under Busan humidity.
PSU Rail Analysis
12V and 6-pin delivery is logged under peak draw. We flag units where single-rail designs sag below tolerance during block-finding spikes.
Cable & Connector Audit
Pin seating, gauge adequacy, and connector temperature are photographed. We document which aftermarket PSUs void manufacturer warranty coverage.
Flagship Consultation
Our most-requested service for new farm builds and single-rig upgrades.
PSU-Matched Miner Selection
A two-hour session at our Jung-gu lab or your facility. We inventory your electrical capacity, shortlist miners above 0.05 TH/s that fit your breaker allocation, and deliver a written PSU pairing report with cable diagrams.
Includes load calculations for up to eight units, vendor-neutral hardware recommendations, and a 30-day email follow-up for installation questions.
View Full Scope
Additional Assessments
Supporting services for operators who already own hardware.
On-Site Power Audit
A technician visits your mining location to measure real-world voltage stability, breaker headroom, and PSU thermal performance under load.
Learn MoreFrom the Field
Recent notes on PSU failures, voltage events, and hardware longevity.
Why Single-Rail PSUs Fail Korean Summer Loads
Single-rail power supplies sag below tolerance when residential voltage drops during peak air-conditioning hours. Here is what we measured in June.
Reading a Miner Nameplate: Wattage vs. Wall Draw
Factory wattage ratings assume ideal conditions. We explain how to translate nameplate numbers into real breaker requirements.
Connector Temperature: The Early Warning Sign
Thermal imaging during on-site audits reveals failing connections weeks before they cause hardware damage.
Operator Voices
Feedback from consultations and on-site audits across South Korea.
The PSU report caught a 20-amp mismatch on our Antminer S19 batch that our electrician had missed. We swapped to dual-rail units before the July heat wave and had zero shutdowns.
— Min-jun Park, Gyeonggi home miner
Thorough cable documentation, though I wish the turnaround had been a day faster. Still, the pairing advice saved us from buying undersized PSUs for our 0.1 TH/s expansion.
— Hye-jin Choi, Daegu small farm operator